How To......?

1. Use the enclosed eyelet screw to enlarge the filling hole located at the top of

the cartridge. (Do not remove the cap.)

2. Connect the needle to the syringe and fill the syringe with 8 ml. of Cartridge

& Print Head Cleaner and inject into the cartridge. Reinsert cartridge into

printer and print 5 test pages.

3. Fill the syringe with ink. Insert the needle into the filling hole and push down

into the cartridge. Inject up to 20 ml. of ink or until the cartridge is full. Note:

Immediately refill any empty cartridges

1. The filling holes are located under the plastic cap. Use a thin flathead screwdriver

or knife to remove the cap. Important: Do not to damage the sensors

on the back of the cartridge.

2. Connect the needle to the syringe and fill with ink.

3. Insert the needle into the matching hole of the color to be refilled, (see diagram

above) and push into the cartridge. Note: You will feel a slight pressure

because the cartridge contains a sponge.

4. Inject about 8 ml. of ink, per color, into the cartridge until the ink begins to

bubble at the top of the sponge. Important: Do not overfill. Keep the sponge

inside the cartridge white.

5. Rinse the needle and syringe with water and dry between each color refilling

or store for future use.

6. The cover can be reattached with a piece of tape.