How To......?

REQUIRED FOR A SUCCESSFUL REFILL:

 Toner

 1 funnel cap

 Smart Chip

General Refilling Procedures:

Use a Flat head screwdriver to pop out the large plastic plug found on the side

of the side of the cartridge.

IMPORTANT: You must dispose of any original toner in the cartridge as

much as possible before refilling. If possible, use a vacuum to remove excess

toner from the cartridge, or use compress air to carefully and gently

blow out any toner inside the toner hopper (Please try to use compressed

air in a well ventilated area) for best results. Dispose of toner properly into

a trash can.

Before opening the bottle of toner, turn it upside down and tap it on a table to

loosen the toner and allow it to flow freely. Remove the cap and pull the seal

off the bottle. Attach the funnel cap making to sure it is on tightly. Tilt the

funnel cap toward the filling hole and insert it into the hole. If the toner stops

flowing before the cartridge is full, simply remove the toner, close the cap,

turn the bottle upside down and tap it on a table. Once the cartridge is full, seal

the hole with the plug by twisting it until it is completely seated. Now gently

shake the cartridge side to side to distribute the toner.

Remember to remove the old chip from the printer and place the new one

before installing the cartridge.