How To......?

REQUIRED FOR A SUCCESSFUL REFILL:

 Toner

 1 Phillips screwdriver and flat head screw driver

 Needle nose pliers

Note: Please read carefully before refilling cartridge.

General Refilling Procedures:

Using the screw driver, remove the screws on the side of the cartridge so that the

sealing plug can be revealed (Illustration A.). Once you have located the sealing

plug, use the flat head screw driver to gently loosen the sealing plug(Illustration

B..). With the needle nose pliers, gently, but forcefully pull the plug completely

off the cartridge. If the plug happens to bent or crack, you may use electrical

tape or duct tape to securely seal the cracks or bents once you have replaced the

plug at the end of the refill process.

Empty any toner left inside the cartridge (mixing two different brands of toner

could result in bad printing, or rare discoloration in your prints).

Before opening the bottle of toner, turn it upside down and tap it on a table to

loosen the toner and allow it to flow freely. Remove the cap and pull the seal off

the bottle. Attach the funnel cap making to sure it is on tightly. Tilt the cartridge

at a 45 degree angle and then the funnel cap toward the filling hole and insert

it into the hole. If the toner stops flowing before the cartridge is full, simply

remove the toner, close the cap, turn the bottle upside down and tap it on a

table. Once you are done refilling this cartridge, place the sealing plug back in

its place and use duct tape or electrical tape to seal up any necessary cracks on

the plug.

Replace the fuse for this cartridge (Illustration B.. shows the fuse compartment).

Once you have replaced the fuse, you may now reinsert your cartridge back into

your printer and begin printing. Changing the fuse is only required for the Dell

1100 and Samsung 2010 cartridge.