How to Refill Okidata Inkjet Cartridges

Black Cartridge:

52109301

1. Use the enclosed eyelet screw to enlarge the filling hole located at the top of the cartridge.

(Do not remove the cap.)

2. Connect the needle to the syringe and fill the syringe with 8 ml. of Cartridge & Print

Head Cleaner and inject into the cartridge. Reinsert cartridge into printer and print 5

test pages.

3. Fill the syringe with ink. Insert the needle into the filling hole and push down into the

cartridge. Inject up to 20 ml. of ink or until the cartridge is full. Note: Immediately

refill any empty cartridges.

Color Cartridge:

52109302

1. The filling holes are located under the plastic cap. Use a thin flathead screw driver or

knife to remove the cap. Important: Do not to damage the sensors on the back of the

cartridge.

2. Connect the needle to the syringe and fill with ink.

3. Insert the needle into the matching hole of the color to be refilled, (see diagram above)

and push into the cartridge. Note: You will feel a slight pressure because the cartridge

contains a sponge.

4. Inject about 8 ml. of ink, per color, into the cartridge until the ink begins to bubble at

the top of the sponge. Important: Do not overfill. Keep the sponge inside the cartridge

white.

5. Rinse the needle and syringe with water and dry between each color refilling or store

for future use.

6. The cover can be reattached with a piece of tape.

52110001, 52110002, 52110003, 52110004

1. The filling hole is located under the label as shown. Just peel back the label

leaving it still connected to the cartridge, do not remove completely.

2. Use the provided eyelet screw to drill a filling hole on the top of the

cartridge(s) opposite side of the sponge.

3. Connect the needle to the syringe and fill with ink.

4. Insert the needle into the filling hole and inject about 5 ml of ink.

5. Use the provided plug to seal the hole. Note: If the cartridge has been empty/

dry, the sponge will no longer accept any ink which will cause the cartridge

to leak. Pull the label back into place and use a piece of tape to hold it in place.

6. Rinse the syringe with water and dry between each color refill or store for

future use.

7. Reinsert cartridge back into the printer and run 1 - 3 cleaning cycles as per

printer instructions.

Note: Immediately refill any empty cartridges

How To......?