How To......?

REQUIRED FOR A SUCCESSFUL REFILL:

 Toner

 1 Phillips screwdriver and flat head screw driver 

Needle nose pliers

Note: Please read carefully before refilling cartridge.

General Refilling Procedures:

Using the screw driver, remove the screws on the side of the cartridge so that the toner plug can

be revealed. Once you have located the toner plug, use the flat head screw driver to gently loosen

the sealing plug. With the needle nose pliers, gently, but forcefully pull the plug completely off

the cartridge. If the plug happens to bent or crack, you may use electrical tape or duct tape to

securely seal the cracks or bents once you have replaced the plug at the end of the refill process.

Empty any toner left inside the cartridge (mixing two different brands of toner could result in bad

printing, and unpredictable results).

Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the toner

and allow it to flow freely. Remove the cap and pull the seal off the bottle. Attach the funnel

cap making to sure it is on tightly. Tilt the cartridge at a 45 degree angle and then the funnel cap

toward the filling hole and insert it into the hole. If the toner stops flowing before the cartridge

is full, simply remove the toner, close the cap, turn the bottle upside down and tap it on a table.

Once you are done refilling this cartridge, place the sealing plug back in its place and use duct

tape or electrical tape to seal up any necessary cracks on the plug.

Replace the Smart Chip on the cartridge before placing it back into the printer. The chip may

need to be pried from its location gently. Once the chip has been replaced, insert the cartridge

into the printer and run a few test pages.