How To......?

#10 (Black and Color)

1. Peel back the sticker at the top of the cartridge to reveal refilling holes. (See picture’s
to the right)
2. Connect the needle to the syringe and fill the syringe with 10 ml of ink for the Black
cartridge or 5 ml of ink for each of the colors in the color cartridge.
3. Insert the needle into the filling hole and push down into the cartridge. (Only push
down about 1/4 of an inch). Fill the cartridge with the proper color and then clean
the syringe with water before moving on to the next color. (Do not cross contaminate
colors. Cleaning the syringe is a must before filling it with the next color).
4. Once your done refilling, try the chip installation chip below before inserting the
cartridge into the printer.


*Chip installation instructions*

Newly refilled Kodak ink cartridges need to have their chips replaced with new
chips so that the printer can “recognize” them as full again.
Aftermarket chips are slightly different in shape to the original chips in order
to better protect them from damage (replacement chips are slightly thicker),
and therefore it is required to modify the chip slot on the cartridge to adequately
hold the replacement chip in place.
1. You will notice that the OEM (original) chip is held in place by a small
plastic protrusion that is holding the chip in place from the bottom of the
chip (see just below the chip, in the middle of the chip). This plastic protrusion
can be depressed easily with a screwdriver or pen tip, releasing
the hold on the chip. The chip will then easily slide downwards,and out.
2. The replacement chip is thicker than the original chip, so the same
plastic protrusion needs to be depressed even more in order to get the
replacement chip to slide in place. The protrusion may need to be physically
bent a little to create the extra space needed to slide the chip place.