How To......?

REQUIRED FOR A SUCCESSFUL REFILL:

 Toner

 1 funnel cap

 Smart Chip

General Refilling Procedures:

1. Identify the filling hole on the side of the cartridge. There may be a sticker over the

filling cap that says “DO NOT REMOVE”. It is OK to remove this sticker. The

plastic sealing cap can be easily removed by prying it out with a flat screwdriver, but

be careful not to damage this plastic cap as you need to place it back after you refill

2. Now you can fill the cartridge with toner. Before opening the bottle of toner, turn

it upside down and tap it on a table to loosen the toner and allow it to flow freely.

Remove the cap and pull the seal off the bottle. Attach the funnel cap making to sure

it is on tightly. Tilt the funnel cap toward the filling hole and insert it into the hole. If

the toner stops flowing before the cartridge is full, simply remove the toner, close the

cap, turn the bottle upside down and tap it on a table. Once the cartridge is full seal

the hole with the original plug.

3. Using a screwdriver, remove the 5 screws that are located on the TOP of the cartridge.

See picture A.

4. Carefully separate the two halves.

5. Locate the smart chip as shown in the image C, and replace it with a new replacement

chip

6. Now replace the cover of the cartridge and replace all 5 screws, making sure the

cover is securely attached.